Grand Cherokee 4WD V8-5.7L (2008)
4. Disengage the retractor lock cable (2) end fitting from the seat back latch mechanism (3) on the upper outboard corner of the seat back panel.
5. Disengage the lock cable from the back panel between the latch and the retractor (1).
6. Remove the screw (2) from the back of the seat back panel (1) that secures the retractor.
7. Remove the rear center seat belt and retractor unit from the front of the left seat back panel.
Rear Outboard
REAR OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts
Catalog.
1. Remove the rear seat cushion from the vehicle. See: Body and Frame/Seats/Seat Cushion/Service and Repair/Seat Cushion - Removal.
2. Loosen the screw (3) that secures the rear outboard seat belt lower anchor and the rear seat back bracket to the rear floor panel.
3. Disengage the lower anchor from the loosened screw.
4. Remove the upper trim from the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Removal.
5. Disengage the seat belt lower anchor from the seat belt opening in the upper C-pillar trim.
6. Remove the trim (5) from the quarter inner panel. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair.
7. Remove the screw (2) that secures the seat belt turning loop to the upper C-pillar.
8. Remove the seat belt turning loop from the upper C-pillar.
9. Remove the screw (4) that secures the retractor (1) to the lower C-pillar.
10. Disengage the retractor locator tab from the slot in the lower C-pillar.
11. Remove the rear outboard seat belt and retractor from the lower C-pillar as a unit.