Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
Parking Assist Control Module: Service and Repair
Installation
INSTALLATION
1. Position the park assist module (3) to the mounting plate (4) and insert the two mounting tabs on the outboard side of the module into the slots in
the plate.
2. Slide the module toward the outboard side of the mounting plate, then push downward on the module until the two latch features integral to the
inboard side of the plate are fully engaged over the mounting tabs on the inboard (connector) side of the module.
3. Reconnect the underbody wire harness connector (2) to the module connector receptacle.
4. Reinstall the rear seat cushion onto the rear floor panel (1).
5. Reconnect the battery negative cable.