Grand Cherokee 4WD V8-5.7L VIN 2 (2007)
8. Rotate the thrust bearing support plate (1) so that the tab (2) is pointed between the two bolt holes (3) as shown.
9. Install the clutch lever assembly (1) onto the mainshaft and shift rail.
10. Apply bead of Mopar(R) Gasket Maker, or equivalent, to mating surface of front case. Keep sealer bead width to maximum of 3 mm (0.125 inch).
Do not use excessive amount of sealer as excess will be displaced into case interior and potentially clog the oil pump screen.
11. Verify that the tab on the thrust bearing support plate is aligned with the housing alignment dowel furthest from the front output shaft.
12. Install the rear housing (1) into the front housing (2).