Grand Cherokee 4WD SRT-8 V8-6.1L VIN 3 (2006)
Alarm Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim from the inside of the right quarter inner panel (2).
3. Disconnect the take out of the body wire harness from the connector receptacle (4) on the rearward side of the intrusion module (1).
4. Remove the two nuts (5) that secure the module to the studs (3) on the quarter inner panel.
5. Remove the module from the studs on the quarter inner panel.
INSTALLATION
1. Position the intrusion module (1) onto the two studs (3) on the right quarter inner panel (2).
2. Install and tighten the two nuts (5) that secure the module to the studs on the quarter inner panel. Tighten the nuts to 2 N.m (20 in. lbs.).
3. Reconnect the take out of the body wire harness to the connector receptacle (4) on the rearward side of the module.
4. Reinstall the trim onto the inside of the right quarter inner panel.
5. Reconnect the battery negative cable.
