Liberty 2WD L4-2.4L VIN 1 (2005)
toward the steering column.
4. Align the SKREEM mounting bracket clip with the right lower flange of the steering column jacket and, push upward firmly and evenly on the
connector end of the module mounting bracket to engage this clip with the steering column.
5. Reconnect the wire harness connector to the SKREEM.
6. Position both the upper and lower shrouds onto the steering column.
7. Align the snap features on the lower shroud with the receptacles in the upper shroud and apply hand pressure to snap them together.
8. From below the steering column, install and tighten the two screws that secure the lower shroud to the upper shroud. Tighten the screws to 2 N.m
(18 in.lbs.).
9. If the vehicle is equipped with a tilt steering column, move the column to the fully raised position and secure it in place by moving the tilt release
lever back to the locked (up) position.
10. Reconnect the negative battery cable.
NOTE: If the Sentry Key REmote Entry Module (SKREEM) is replaced with a new unit, a diagnostic scan tool MUST be used to initialize the
new SKREEM and to program at least two Sentry Key transponders before the vehicle can be operated.