Liberty 2WD V6-3.7L (2008)
Parking Assist Control Module: Service and Repair
Installation
INSTALLATION
1. Position the park assist module (2) to the right quarter inner panel (1) behind and above the right rear wheel house, forward of the D-pillar.
2. Secure the module to the right quarter inner panel using three plastic push-in fasteners (3).
3. Reconnect the two body wire harness connectors (4) to the module connector receptacles.
4. Reinstall the trim onto the right quarter inner panel.See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Console Shifter
Bezel - Installation.
5. Reconnect the battery negative cable.
