Liberty 2WD V6-3.7L (2008)
Rear Door Interior Handle: Service and Repair
Rear Door Interior Handle - Installation
INSTALLATION
1. Install the handle (2) and spring (3) to the carrier.
2. Install the push pin (1) into the carrier, spring and the handle.
NOTE: Make sure that the push pin is seated flush with the carrier.
3. Install the interior lock rod to the interior handle (2). Make sure the lock rod is positioned properly to the carrier (1).
4. Install the door trim panel, See: Rear Door Panel/Service and Repair/Rear Door Trim Panel - Installation.
