Liberty 2WD V6-3.7L (2008)
1. Align and install the trim panel clips (3) rearward and into quarter trim panel.
2. Push the trim panel (2) down into the body (4) using hand pressure until all clips are seated.
3. Align and install the trim panel (2) to the body slots (1) on the B-pillar. Snap into place using hand pressure.
Upper Cover
INSTALLATION
1. Feed the seatbelt webbing through the B-pillar trim (2). Slide the belt adjuster to top position.
2. Install the trim (2) by sliding down and into the B-pillar lower trim.
3. Align the 4-way locator and seat the B-pillar trim (2) to the body.
4. Install the screw and screw cover.
5. Install the seat belt bolt (3) and tighten to 44.5 Nm (33 ft. lbs.).
C-Pillar Trim Panel-Removal
REMOVAL