Liberty 2WD V6-3.7L (2008)
8. Remove the two screws from the rear of the outer seat trim and remove the trim panel.
9. Remove the seat position sensor.
CAUTION: The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to
prevent binding that could result in tab breakage.
10. Position the right front seat to the full rearward position.
11. Disconnect and isolate the battery negative cable.
12. Disconnect the wire harness connector (4) from the heated seat module (3).
13. Unsnap the heated seat module retaining tab (2) from the seat pan (1).
14. Remove the heated seat module (3) from the vehicle.
15. Remove the three nuts and remove the left seat track.
16. Remove the three nuts and remove the right seat track.
17. Remove the electrical harness from the seat bottom.
