Liberty 2WD V6-3.7L (2008)
Traction Control Switch: Service and Repair
Installation
INSTALLATION
NOTE: There are different accessory switch banks available based on the option content of the vehicle. Ensure the switch pod being installed
matches the vehicle options.
1. Position the accessory switch bank (3) onto the back of the instrument panel center bezel (1).
2. Install the four screws (2) that secure the accessory switch bank to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the center bezel onto the instrument panel, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Center Bezel - Installation.
4. Connect the battery negative cable.
5. Verify esp system operation.