Liberty 2WD V6-3.7L (2008)
Radiator: Removal and Replacement
Radiator - Removal
REMOVAL
WARNING: Do not remove the cylinder block drain plugs or loosen the radiator draincock with the system hot and under pressure. Serious
burns from coolant can occur. Refer to cooling system draining.
Do not waste reusable coolant. If the solution is clean, drain the coolant into a clean container for reuse.
CAUTION: When removing the radiator or A/C condenser for any reason, note the location of all radiator-to-body and radiator-to-A/C
condenser rubber air seals. These are used at the top, bottom and sides of the radiator and A/C condenser. To prevent overheating, these seals
must be installed to their original positions.
1. Disconnect the negative battery cable at battery.
2. Drain coolant from radiator See: Service and Repair.
3. Remove the front grille See: Body and Frame/Grille/Service and Repair/Grille - Removal.
4. Remove the cooling fan from the engine, if equipped.
5. Remove the two radiator mounting bolts.
6. Disconnect the connector for the electric fan.
7. Disconnect the power steering cooler line from cooler.
8. Disconnect the radiator upper and lower hoses.
9. Disconnect the overflow hose from radiator (2).