Liberty 2WD V6-3.7L (2008)
Hose/Line HVAC: Service and Repair
A/C Line - Removal
Discharge Line
3.7L ENGINE
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions could result in possible personal
injury or death.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Procedures/Refrigerant System Recovery.
3. Remove the air cleaner housing See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Air
Filter Element/Service and Repair/Removal.
4. Remove the nut (2) that secures the A/C discharge line (3) to the A/C compressor (4).
5. Disconnect the A/C discharge line from the A/C compressor and remove and discard the O-ring seal and gasket.
6. Remove the grille See: Body and Frame/Grille/Service and Repair/Grille - Removal.
7. Remove the nut (4) that secures the A/C discharge line (5) to the A/C condenser (3).
8. Remove the bolt (2) that secures the A/C condenser to the right side of the radiator (1).
9. For clearance, position the A/C condenser toward the left side of the vehicle and then disconnect the A/C discharge line from the condenser.
10. Remove and discard the O-ring seal and gasket from the discharge line fitting.
11. Remove the A/C discharge line from the engine compartment and install plugs in, or tape over the opened discharge line fittings and the
compressor and condenser ports.
Liquid Line
LHD MODEL