Liberty 2WD V6-3.7L (2008)
Center Mounted Brake Lamp: Service and Repair
Center High Mounted Stop Lamp - Installation
LAMP
1. Check to be certain that the two plastic nuts (4) are properly installed and in good condition on each side of the Center High Mounted Stop Lamp
(CHMSL) (6) opening in the upper header of the liftgate outer panel (1).
2. Position the CHMSL near the liftgate opening.
3. Reconnect the liftgate wire harness connector (5) to the back of the lamp housing.
4. Reconnect the washer supply hose (3) to the barbed nipple of the rear washer nozzle at the back of the lamp housing.
5. Position the CHMSL into the liftgate opening with the lower edge slightly away from the liftgate.
6. Move the CHMSL left-to-right to align the temporary locator on the back of the CHMSL with the locator notch in the liftgate opening.
7. Slide the CHMSL slightly upward then rock the lower edge into the opening so that the retention feature holds the CHMSL to the liftgate without
fasteners.
8. Install and tighten the right side screw (2) that secures the CHMSL to the liftgate, followed by the left side screw. Tighten the screws to 2.5 Nm
(20 in. lbs.).
9. Reconnect the battery negative cable.
