Liberty 2WD V6-3.7L (2008)
airbag instrument panel bracket to the instrument panel structural duct. Tighten the screw to 2.9 Nm (25 in. lbs.).
8. Position the screw guide (3) onto the top of the instrument panel (2) near the windshield (1) and, using hand pressure, press the screw guide
downward until both integral latch features snap into place.
9. Install and tighten the two screws (4) through the screw guide that secure the instrument panel bracket for the passenger airbag to the dash panel.
Tighten the screws to 29.5 Nm (21.5 ft. lbs.).
10. Using hand pressure, press the top of the passenger airbag door forward and downward until each snap feature on the upper edge of the airbag
door is fully engaged into its receptacle in the instrument panel base trim.
11. Using hand pressure, wrap the passenger airbag door downward tightly against the instrument panel, then push forward until each snap feature on
the lower edge of the airbag door is fully engaged into its receptacle in the instrument panel base trim.
12. Visually verify that each of the snap features of the airbag door is fully engaged in the instrument panel. There will be a distinct bulge in the door
over any snap that is not fully engaged.
13. Reinstall the top cover onto the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Defroster Grille/Installation.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test