Liberty 2WD V6-3.7L (2008)
Battery Tray: Service and Repair
Battery Tray - Removal
REMOVAL
NOTE: Left hand drive gasoline engine shown, right hand drive and diesel similar.
1. Disconnect and isolate the battery negative cable.
2. Remove the battery, See: Service and Repair/Removal and Replacement/Battery - Removal.
3. On gasoline engine equipped vehicles, disconnect the purge solenoid vacuum hose and electrical connector (1). Using an appropriate flat bladed
tool, remove the solenoid (4) from the battery tray (3) by disengaging the solenoid mounting clip and lifting it up off the battery tray mounting tab.
4. Open the Totally Integrated Power Module (TIPM) cover (4).
5. Remove the TIPM positive cable retaining nut (1) and remove the cable (2) from the mounting stud (3).
