Liberty 2WD V6-3.7L (2008)
Power Distribution Module: Service and Repair
Module-Inverter
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear seat assembly, See: Body and Frame/Seats/Service and Repair/Seat - Removal.
3. Remove the fasteners (1) from the mounting brackets of the inverter module (2).
4. Remove the inverter module.
Installation
INSTALLATION
1. Position the inverter module (2) on the mounting bracket assembly.
2. Install the fasteners (1).
3. Install the rear seat assembly, See: Body and Frame/Seats/Service and Repair/Seat - Installation.
4. Connect the battery negative cable.