Liberty 2WD V6-3.7L (2008)
Front Steering Knuckle: Service and Repair
Front Steering Knuckle - Removal
REMOVAL
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the caliper adapter. See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Disc Brake Caliper Adapter - Removal.
CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable
support to hang the caliper securely.
4. Remove the disc brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal.
5. Remove the wheel speed sensor. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service and
Repair/Front Wheel Speed Sensor - Removal.
6. Remove the axle shaft nut. (if equipped with four wheel drive)
7. Remove the outer tie rod nut (2).
8. Separate the outer tie rod end (1) from the steering knuckle (3) using tool 9360 (2). See: Steering/Tie Rod/Tie Rod End/Service and Repair/Tie
Rod End - Removal.