Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
Camshaft Oil Seal: Service and Repair
CAMSHAFT OIL SEAL(S)
REMOVAL
1. Remove timing belt.
2. Hold each camshaft sprocket with Special Tool 6847 while removing center bolt (Fig. 12).
3. Remove camshaft sprockets.
4. Remove exhaust camshaft target ring.
5. Remove exhaust camshaft sensor.
CAUTION: Inspect sensor and target ring for excessive wear. Clean sensor face and install new spacer pad.
6. Remove rear timing belt cover.
7. Remove camshaft seal using Special Tool C-4679-A (Fig. 13).
CAUTION: Do not nick shaft seal surface or seal bore.
INSTALLATION
NOTE: Clean and inspect sensor and target ring for excessive wear. Clean sensor face and always install a new spacer pad.
1. Shaft seal surface must be free of varnish, dirt or nicks. Polish with 400 grit paper if necessary.