Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
10. Install 6 mm Allen wrench into belt tensioner. Before rotating the tensioner, insert the long end of a 1/8 inch or 3 mm Allen wrench into the pin
hole on the front of the tensioner (Fig. 103). While rotating the tensioner counterclockwise, push in lightly on the 1/8 inch or 3 mm Allen wrench,
until it slides into the locking hole.
11. Remove timing belt.
CRANKSHAFT SPROCKET
1. Disconnect negative battery cable.
2. Remove timing belt.
3. Remove crankshaft sprocket using Special Tools 6793 and insert C-4685-C2 (Fig. 104).
CLEANING
Do Not attempt to clean a timing belt. If contamination from oil, grease, or coolants have occurred, the timing belt should be replaced.
Clean all sprockets using a suitable solvent. Clean all sprocket grooves of any debris.
INSTALLATION
CRANKSHAFT SPROCKET
CAUTION: The crankshaft sprocket is set to a predetermined depth from the factory for correct timing belt tracking. If removed, use of Special Tool
6792 is required to set the sprocket to original installation depth. An incorrectly installed sprocket will result in timing belt and engine damage.