Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
1. Install new O-ring gasket in water pump body O-ring locating groove (Fig. 32).
CAUTION: Make sure O-ring is properly seated in water pump groove before tightening screws. An improperly located O-ring may be damaged
and cause a coolant leak.
2. Assemble pump body to block and tighten screws to 12 Nm (105 inch lbs.). Pressurize cooling system to 103.4 kPa (15 psi) with pressure tester
and check water pump shaft seal and O-ring for leaks.
3. Rotate pump by hand to check for freedom of movement.
4. Install the timing belt rear cover.
5. Install camshaft sprockets and target ring. Torque bolts to 101 Nm (75 ft. lbs.) while holding camshaft sprocket with Special tool C-4687 and
adaptor C-4687-1.
6. Install timing belt idler pulley and torque mounting bolt to 61 Nm (45 ft. lbs.).
7. Install the timing belt.
8. Install the accessory drive mounting bracket (Fig. 33).
9. Install the power steering pump.
10. Install the generator.