Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
Fuel Pump Module location
3. Position Special Tool 9340 3.into notches on outside edge of lockring (5).
4. Install 1/2 inch drive breaker bar (1). to tool 9340 (3).
5. Rotate breaker bar counter-clockwise to remove lockring (5).
6. Remove lockring. The module will spring up slightly when lockring is removed.
7. Remove module from fuel tank. Be careful not to bend float arm while removing.
INSTALLATION
A typical fuel pump module is displayed in the graphic.
1. Using a new seal (gasket), position fuel pump module into opening in fuel tank.
Fuel Pump Module Location
2. Position lockring (5).over top of fuel pump module.
3. Rotate module until embossed alignment arrow points to center alignment mark. This step must be performed to prevent float from contacting side
of fuel tank.
4. Install Special Tool 9340 (3)to lockring.
5. Install 1/2 inch drive breaker (1). into Special Tool 9340 (3).
6. Tighten lockring (clockwise) until all seven notches have engaged.
7. Install fuel tank.