Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
Spark Plug: Service and Repair
Removal and Installation
REMOVAL
If spark plug for #2 or #3 cylinder is being removed, throttle body must be removed.
1. Remove air cleaner tube and housing.
2. Twist secondary cable at cylinder head to break loose at spark plug. Remove cable from plug.
3. Prior to removing spark plug, spray compressed air into cylinder head opening. This will help prevent foreign material from entering combustion
chamber.
4. Remove spark plug from cylinder head using a quality socket with a rubber or foam insert.
5. Inspect spark plug condition. Refer to Spark Plug Conditions.
INSTALLATION
CAUTION: Spark plug tightening on the 2.4L is torque critical. The plugs are equipped with tapered seats. Do not exceed 15 ft. lbs. torque.
Special care should be taken when installing spark plugs into the cylinder head spark plug wells. Be sure the plugs do not drop into the plug wells as
electrodes can be damaged.
Always tighten spark plugs to the specified torque. Over tightening can cause distortion resulting in a change in the spark plug gap or a cracked porcelain
insulator.
1. Start the spark plug into the cylinder head by hand to avoid cross threading.
2. Tighten spark plugs. Refer to torque specifications.
3. Install throttle body.
4. Install air cleaner tube and housing.