Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
7.
Lubricate the new rear wheel speed sensor and 0-ring
8.
Install the new rear wheel speed sensor, p/n 56041393AA, to the axle. Tighten the attaching bolt to 9 Nm (80 in.lbs.).
9.
Verify that the seal is securely in place between the sensor and wiring connector. Install the sensor electrical connector to the sensor.
10.
Apply a bead of Axle RTV sealant, p/n 05013477AA, to the differential housing cover.
CAUTION:
If cover is not installed within 3 to 5 minutes of new RTV sealant application, the cover must be cleaned and new RTV sealant applied. Failure to
follow instructions will cause a leak.
11.
Install the cover and identification tag. Tighten cover bolts in a criss-cross pattern to 41 Nm (30 ft. lbs.).
12.
If not already removed, remove the fill plug.
13.
If axle is equipped with a Trac-Lok differential, install 4 oz. of Limited Slip Additive to the differential.
14.
Fill the axle differential with the correct axle lubricant.
15.
Install the fill plug.
16.
Verify that the rear wheel speed sensor and differential housing cover is correctly installed.
17.
Lower vehicle.
18.
Connect the negative battery cable to the battery. Set the clock to the correct time.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
