Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
18. Verify the operation of the window before installing the door panel.
19. Does any of the repaired windows exhibit a chatter condition during its up or down travel after making the Lift plate repair?
a. Yes >>> proceed to Step # 20
b. No >>> Complete the reassembly of the inner door panel and related components. No further repair needed. Repair complete
20. If the chatter is eliminated when water is sprayed onto the window channel run, the window channel needs to be replaced.
21. Following the procedures in DealerCONNECT > TechCONNECT under: Service Info > 23 - Body > Door-Front/Door-Rear > Channel, Door
Glass, to replace the Glass Run Channel Seal.
22. Verify the operation of the window.
23. Complete the reassembly of the inner door panel and related components.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
Technical Service Bulletin # 23-025-10A Date:
101204
Body - Front/Rear Windows Bind/Stick/Tip/Inoperative
NUMBER: 23-025-10 REV A
GROUP: Body
DATE: December 04, 2010
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 23-025-10, DATED DECEMBER 1, 2010, WHICH SHOULD BE
REMOVED FROM YOUR FILES. ALL REVISIONS AND ARE HIGHLIGHTED **ASTERISKS** AND INCLUDE CORRECTED LOP'S.
STANDARD REGULATOR REPAIR PROCESSES OUTLINED IN DEALERCONNECT HAVE BEEN REMOVED.
SUBJECT:
Front Or Rear Window Bind, Stick, Tip's or Is Inoperative