Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
Sunroof / Moonroof Module: Service and Repair
MODULE/FRAME ASSEMBLY
REMOVAL
1. Move glass panel to fully closed position.
2. Disconnect and isolate negative battery cable.
3. Remove sunroof opening trim lace.
4. Remove control switch.
5. Remove headliner.
6. Disconnect wire harness push in fasteners (1) and electrical connector (2) from vehicle harness (3).
7. Disconnect drain tubes from sunroof housing.
8. Cut foam support pad at rear of module if necessary.
9. Remove two module bracket bolts and loosen the remaining fasteners.
10. With the aid of a helper, remove fasteners attaching sunroof module assembly to roof panel.
11. Remove the sunshade.
12. Remove the drive motor.
13. Remove the wire harness.
14. Remove the trough guides.