Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
Gear Sensor/Switch: Service and Repair
Transfer Case - NV242
SENSOR-POSITION
REMOVAL
1. Raise and support the vehicle.
2. Disengage the transfer case position sensor connector from the position sensor (2).
3. Remove the position sensor from the transfer case.
INSTALLATION
1. Inspect the O-ring seal on the transfer case position sensor. Replace the O-ring if necessary.
2. Install the transfer case position sensor into the transfer case. Torque the sensor to 27 Nm (20 ft. lbs.).
3. Engage the transfer case position sensor connector to the position sensor.
4. Lower vehicle.
5. Verify proper sensor operation.