Liberty 4WD V6-3.7L (2009)
6. Remove the three screws (2) and separate the front motor (3) from the roof system.
NOTE: Discard the screws (2) and replace with service screws and washers.
7. Disconnect the electrical connector (1) and remove the motor.
8. Manually position the front bow and drive assembly (1) forward fully.
CAUTION: When moving the drive assemblies without the motors attached make sure that the assemblies are moved straight back.
9. Manually position the rear drive assembly about 300 mm (12 inches) open, See:
10. Separate the headliner hook and loop strip (3) and expose the drive mechanism.
11. Remove the five screws (2) and separate the cover assembly from the drive (1).
12. Remove the three screws (2) and separate the rear motor (3) from the roof system.