Liberty 4WD V6-3.7L (2009)
Evaporator Temperature Sensor / Switch: Service and Repair
Evaporator Temperature Sensor - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Illustration shown with instrument panel removed for clarity.
NOTE: LHD model shown. RHD model similar.
1. Disconnect and isolate the negative battery cable.
2. Partially remove the instrument panel to gain access to the evaporator temperature sensor (1) located in the rear of the HVAC housing (2), near the
bottom of the instrument panel on the passenger side See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel - Removal.
3. Disconnect the instrument panel wire harness connector from the evaporator temperature sensor and remove the sensor from the HVAC housing.