Liberty 4WD V6-3.7L (2009)
Dome Lamp Bulb: Service and Repair
Dome Lamp - Installation
Front
BULB - FRONT
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. With the dome lamp lens (1) in the open position, align the ends of the bulb (3) with the two bulb holders within the front dome lamp housing (2).
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
3. Reinstall the lamp into the headliner. See: .
4. Reconnect the battery negative cable.
Second Row
BULB - SECOND ROW
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The second row reading lamps are integral to the grab handle in the headliner on the inner roof side rail over each outboard rear
seating position.
1. Align the base of the bulb (1) with the bulb holder within the reading lamp housing.
2. Push the bulb into the holder until the base is fully seated.