Liberty 4WD V6-3.7L (2009)
Seals and Gaskets: Service and Repair
MP1522 Transfer Case
Input Shaft Seal - Removal
REMOVAL
1. Remove the transfer case from the vehicle See: Service and Repair/Removal and Replacement/MP1522 Transfer Case - Removal
2. Remove the input shaft seal with a suitable pry tool or a screw mounted in a slide hammer.
Input Shaft Seal - Installation
INSTALLATION
NOTE: Lubricate all seals with MOPAR(R) ATF+4 prior to installation.
1. Install the new input shaft seal with Installer 9672 and Handle C-4171.
2. Install the transfer case into the vehicleSee: Service and Repair/Removal and Replacement/MP1522 Transfer Case - Installation
3. Check the transfer case fluidSee: Service and Repair/Procedures
Front Output Shaft Seal - Removal
REMOVAL
The front output shaft seal and wear sleeve cannot be serviced in the vehicle. The transfer case must be disassembled to remove the front output shaft
assembly and seal.
Rear Output Shaft Seal - Removal
REMOVAL