Liberty Limited Edition 2WD V6-3.7L VIN K (2002)
![background image](/jeep/liberty_limited_edition_2wd/v6-3.7l_vin_k/Page-2421001.png)
Keyless Entry Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the Junction Block (JB) (Refer to POWER DISTRIBUTION/JUNCTION BLOCK - REMOVAL).
Fig.5 RKE Module Remove/Install
3. Remove Remote Keyless Entry module from Body Control Module.
INSTALLATION
1. Install Remote Keyless Entry module to Body Control Module.
2. Install Junction Block (JB) (Refer to POWER DISTRIBUTION/JUNCTION BLOCK - INSTALLATION).
3. Connect the battery negative cable.