jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Engine Oil|Capacity Specifications|Page 1806 > < Engine Oil|Capacity Specifications|Page 1804
Page 1
background image

Engine Oil: Testing and Inspection

CRANKCASE OIL LEVEL INSPECTION 

CAUTION:  Do not overfill crankcase with engine oil, pressure loss or oil foaming can result.

Inspect engine oil level approximately every 800 kilometers (500 miles). Unless the engine has exhibited loss of oil pressure, run the engine for about
five minutes before checking oil level. Checking engine oil level on a cold engine is not accurate. To ensure proper lubrication of an engine, the
engine oil must be maintained at an acceptable level. The acceptable levels are indicated between the ADD and SAFE marks on the engine oil
dipstick.

1. Position vehicle on level surface.
2. With engine OFF, allow approximately ten minutes for oil to settle to bottom of crankcase, remove engine oil dipstick.
3. Wipe dipstick clean.
4. Install dipstick and verify it is seated in the tube.
5. Remove dipstick, with handle held above the tip, take oil level reading.
6. Add oil if level is below the SAFE ZONE on dipstick.

Engine Oil|Capacity Specifications|Page 1806 > < Engine Oil|Capacity Specifications|Page 1804