Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Brake Hose/Line: Service and Repair
Brake Tube Flaring
Double Inverted Flaring
STANDARD PROCEDURE - DOUBLE INVERTED FLARING
A preformed metal brake tube is recommended and preferred for all repairs. However, double-wall steel tube can be used for emergency repair when
factory replacement parts are not readily available.
Special bending tools are needed to avoid kinking or twisting of metal brake tubes. Special flaring tools are needed to make a double inverted flare or
ISO flare.
1. Cut off damaged tube with Tubing Cutter.
2. Ream cut edges of tubing to ensure proper flare.
3. Install replacement tube nut on the tube.
4. Insert tube in flaring tool.
5. Place gauge form over the end of the tube.
6. Push tubing through flaring tool jaws until tube contacts recessed notch in gauge that matches tube diameter.
7. Tighten the tool bar on the tube
Cutting And Flaring Of Brake Fluid Tubing
8. Insert plug on gauge in the tube. Then swing compression disc over gauge and center tapered flaring screw in recess of compression disc.
9. Tighten tool handle until plug gauge is squarely seated on jaws of flaring tool. This will start the inverted flare.
10. Remove the plug gauge and complete the inverted flare.
ISO Flaring
STANDARD PROCEDURE - ISO FLARING
A preformed metal brake tube is recommended and preferred for all repairs. However, double-wall steel tube can be used for emergency repair when
factory replacement parts are not readily available. Special bending tools are needed to avoid kinking or twisting of metal brake tubes. Special flaring
tools are needed to make a double inverted flare or ISO flare.
To make a ISO flare use a ISO brake flaring tool or equivalent.
1. Cut off damaged tube with Tubing Cutter.
2. Remove any burrs from the inside of the tube.
3. Install tube nut on the tube.