Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Manifold Pressure/Vacuum Sensor: Service and Repair
REMOVAL
Fig.17 MAP Sensor Location - 2.4L
Fig.10 MAP Sensor (O-Ring)
The Manifold Absolute Pressure (MAP) sensor is mounted into the rear of the intake manifold. An O-ring is used to seal the sensor to the intake
manifold.
1. Disconnect electrical connector at sensor.
2. Clean area around MAP sensor.
3. Remove sensor mounting screw (TORX head).
4. Remove MAP sensor from intake manifold.
5. Check condition of sensor O-ring.
INSTALLATION