Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Fig.34 Seat Back Latch Cable Disengage/Engage
10. Disengage the seat back latch cable fitting from the cable support on the retractor, which is a light snap fit.
Fig.35 Rear Center Retractor Remove/Install
11. Remove the screw that secures the retractor to the rear seat back panel.
12. Remove the rear center seat belt and retractor unit from the seat back panel.
INSTALLATION
WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES,
MOUNTING HARDWARE, AND RETRACTORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY
BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS.
REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS
A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT.
ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED
REPLACEMENT PARTS LISTED IN THE MOPAR PARTS CATALOG.
1. Position the rear center seat belt and retractor unit onto the seat back panel.
2. Install and tighten the screw that secures the retractor to the rear seat back panel. Tighten the screw to 27 Nm (20 ft. lbs.).
3. Position the seat back latch cable plunger against the retractor latch lever, then engage the cable fitting into the cable support on the retractor,
which is a light snap fit.
4. Route the rear seat belt lower anchor and belt web guide through the top of the seat back panel.
