Liberty Sport 4WD L4-2.4L VIN 1 (2002)
CAUTION: When servicing exhaust system components, disconnect the oxygen sensor connector. Allowing the exhaust system to hang by the
oxygen sensor harness will damage the wiring and/or sensor.
1. Position muffler and tailpipe assembly into vehicle.
2. Install rear hanger into isolator.
3. Install front hanger into isolator.
4. Make sure the exhaust system is in proper alignment. There should be at least 25 mm (1 inch) clearance between the exhaust components and any
surrounding components.
5. Tighten muffler to front pipe nuts to 28.5 Nm (21 ft. lbs.).
6. Tighten tailpipe clamp to 27 Nm (16 ft. lbs.).
7. Lower vehicle.
8. Start vehicle and inspect for exhaust leaks.
9. Check the exhaust system for contact with the body panels. make necessary adjustments, if necessary.