Liberty Sport 4WD L4-2.4L VIN 1 (2002)
Center Mounted Brake Lamp Bulb: Service and Repair
Center High Mounted Stop Lamp (CHMSL) Bulb Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the Center High Mounted Stop Lamp (CHMSL) unit from the roof panel. (Refer to LAMPS/LIGHTING - EXTERIOR/CENTER HIGH
MOUNTED STOP LAMP UNIT - REMOVAL).
3. Firmly grasp the socket on the back of the CHMSL unit housing.
Fig.6 Center High Mounted Stop Lamp Bulb Remove/Install
4. Rotate the socket on the back of the CHMSL unit housing counterclockwise about 30 degrees.
5. Pull the socket and bulb straight out of the back of CHMSL unit housing.
6. Pull the bulb straight out of the CHMSL unit socket.
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp,
the socket andlor the lamp wiring.
1. Align the base of the bulb with the receptacle in the Center High Mounted Stop Lamp (CHMSL) unit socket.
2. Push the bulb straight into the CHMSL unit socket until it is firmly seated.
3. Align the socket and bulb with the socket opening on the back of CHMSL unit housing.
4. Push the socket and bulb straight into the CHMSL unit housing until it is firmly seated.
5. Rotate the socket on the back of the CHMSL unit housing clockwise about 30 degrees.
6. Reinstall the CHMSL unit onto the roof panel (Refer to LAMPS/LIGHTING - EXTERIOR/CENTER HIGH MOUNTED STOP LAMP UNIT -
INSTALLATION).
7. Reconnect the battery negative cable.
