Liberty Sport 4WD L4-2.4L VIN 1 (2002)
Fig.67 Trailer Tow Relay Remove/Install
6. Remove the trailer tow relay by grasping it firmly and pulling it straight out from the connector bank (Fig. 67).
INSTALLATION
The trailer tow relay bank contains four relays. The service procedures for each relay are the same. Be certain any removed relay is replaced with the
same relay size and type that was removed.
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, SEAT BELT
TENSIONER, FRONT IMPACT SENSORS, SIDE CURTAIN AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE
SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Position the trailer tow relay to the proper connector in the connector bank (Fig. 67).
2. Align the trailer tow relay terminals with the terminal cavities in the connector.
3. Push firmly and evenly on the top of the trailer tow relay until the terminals are fully seated in the terminal cavities in the connector.
4. Carefully restore the foam wrap around the trailer tow relay connector bank (Fig. 66).
5. Reach through the access hole in the quarter inner panel behind the right rear wheelhouse to place the trailer tow relay connector bank on the top
of the right rear wheelhouse between the quarter inner and outer panels.
6. Reinstall the trim onto the right side quarter inner panel.
7. Reconnect the battery negative cable.
