Liberty Sport 4WD L4-2.4L VIN 1 (2002)
Wiper Relay: Service and Repair
Wiper High/Low Relay Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.27 Power Distribution Center
2. Remove the cover from the Power Distribution Center (PDC) .
3. Remove the wiper high/low relay by grasping it firmly and pulling it straight out from the receptacle in the PDC.
INSTALLATION
1. Position the wiper high/low relay to the proper receptacle in the Power Distribution Center (PDC).
2. Align the wiper high/low relay terminals with the terminal cavities in the PDC receptacle.
3. Push firmly and evenly on the top of the wiper high/low relay until the terminals are fully seated in the terminal cavities in the PDC receptacle.
4. Reinstall the cover onto the PDC.
5. Reconnect the battery negative cable.