Patriot 2WD L4-2.4L (2009)
9. Position the blower motor resistor (6) into the HVAC housing.
10. Install the two screws (5) that secure the blower motor resistor to the HVAC housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
11. Install the air inlet housing (3) onto the HVAC housing (1) See: Removal and Replacement/HVAC Housing - Installation.
12. Install the air distribution housing (2) onto the HVAC housing See: Removal and Replacement/HVAC Housing - Installation.
NOTE: If the heater core is being replaced, flush the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair .
13. Install the HVAC housing assembly See: Removal and Replacement/HVAC Housing - Installation.