Patriot 4WD L4-2.4L (2009)
7. Position one end of the boot snap-ring (1) inside the boot outer lip (2), then making a circular motion, walk the snap-ring around the boot lip,
completely installing and seating it.
8. Inspect whether the two ends of the boot snap-ring are not overlapping one another. If they are, push the snap ring and dust boot further into
groove removing any overlap of the snap-ring.
9. Install the caliper on the vehicle and bleed the brakes as necessary. See: Removal and Replacement/Disc Brake Caliper - Installation
Front
ASSEMBLY
NOTE: Always have clean hands when assembling a brake caliper.
NOTE: Always use fresh, clean brake fluid when assembling a brake caliper.
NOTE: Never use an old piston seal.
1. Dip the NEW piston seal in clean brake fluid and install it in the groove (2) of the caliper bore. The seal (1) should be started at one area of the
groove and gently worked around into the groove using only your clean fingers to seat it.