Patriot 4WD L4-2.4L (2009)
Oil Pressure Switch (For Fuel Pump): Service and Repair
Oil Pressure Switch - Installation
INSTALLATION
NOTE: If the oil pressure switch is removed, it must be replaced with a new switch.
CAUTION: The oil pressure switch has tapered threads, over tightening could crack the engine block.
1. Install the oil pressure switch using oil pressure socket C-4597 (1) or equivalent. Tighten switch to 8 Nm (71 in. lbs.).
2. Connect the oil pressure switch electrical connector.
3. Position the A/C compressor (1) and install three mounting bolts (2). Tighten bolts to 25 Nm (18 ft. lbs.).
4. Install the accessory drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Serpentine Accessory Drive Belt - Installation
5. Install the splash shield to the right side frame rail See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Splash
Shield - Installation
6. Install the front skid plate, if equipped See: Body and Frame/Frame/Skid Plate/Service and Repair/Skid Plate - Installation
7. Reconnect the negative battery cable.