Patriot 4WD L4-2.4L (2009)
ALL WHEEL DRIVE (AWD)
1. Install a new maniverter gasket. DO NOT APPLY SEALER.
2. Position maniverter (1) in place. Tighten fasteners, starting at center and progressing outward in both directions to 34 Nm (300 in. lbs.). Raise and
lower vehicle for fastener access as necessary. Repeat tightening procedure until all fasteners are at specified torque.
3. Install coolant adapter (3)See: Cooling System/Thermostat/Service and Repair/Engine Coolant Thermostat - Installation.
4. Install maniverter heat shields (3). Tighten bolts (1) to 12 Nm (105 in. lbs.).