Patriot 4WD L4-2.4L (2009)
4. Remove the three bolts (3) from the center support heat shield (2).
5. Remove the heat shield (2).
CAUTION: Propeller shaft removal. Never allow propeller shaft to hang while connected to Power Transfer Unit (PTU), rear driveline module
flanges or center bearings. If propeller shaft section is hung unsupported, damage may occur to joint, boot and/or center bearing
from over-angulation. This may result in vibration/balance issues. A helper may be needed.
6. Remove the two center support mounting bolts (3).