jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Standard Procedure|Page 10477 > < Standard Procedure|Page 10475
Page 2
background image

Lamp - With Flashlight Feature

LAMP - WITH FLASHLIGHT FEATURE

NOTE:  There are two types of cargo lamps available in this vehicle; one with and one without a removable flashlight feature.

1. Disconnect and isolate the battery negative cable.

2. Remove the flashlight from the cargo lamp housing (1).

3. Remove the trim from the inside of both upper D-pillars.

4. Remove the push pin fastener (4) adjacent to each side of the cargo lamp that secures the headliner (5) to the upper D-pillar reinforcement (2).

5. Carefully pull down the rear edge of the headliner from the upper liftgate opening header (3) far enough to insert a trim stick or another suitable

wide flat-bladed tool between the back of the lamp housing and the header.

6. Gently pry the lamp housing (1) downward far enough to disengage the snap clip retainer (3) from the upper liftgate opening header.

7. Reach between the headliner and the header to access and depress the two spring tabs (2) far enough to disengage the forward edge of the lamp

housing from the mounting hole in the headliner.

8. Slide the lamp housing forward far enough to disengage the two fixed retainers (5) from the rear edge of the headliner mounting hole.

9. Pull the lamp downward from the headliner far enough to access and disconnect the headliner wire harness connector from the connector

receptacle (4) on the back of the lamp housing.

10. Remove the cargo lamp from the vehicle.

Lamp - Without Flashlight Feature

Standard Procedure|Page 10477 > < Standard Procedure|Page 10475