Patriot 4WD L4-2.4L VIN W (2007)
Turn Signal Bulb: Service and Repair
Rear Lamp Unit
Removal
BULB - DOMESTIC
Compass
Patriot
NOTE: The rear lamp unit (2) contains three bulbs. They are: backup (3), park/stop/rear side marker (1), and turn signal (4). The service procedures for
each bulb are the same, only the bulb sizes and types may differ.
1. Disconnect and isolate the battery negative cable.
2. Remove the rear lamp unit (2) from the end of the quarter panel.
3. Firmly grasp the appropriate bulb socket (1, 3 or 4) on the back of the rear lamp unit housing and rotate it counterclockwise about 30 degrees to
unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.
Installation
BULB - DOMESTIC
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the