Patriot 4WD L4-2.4L VIN W (2007)
Turn Signal Bulb: Service and Repair
Repeater Lamp
Removal
BULB
NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Disconnect and isolate the battery negative cable.
2. Remove the repeater lamp from the fender mounting hole, but do not disconnect the wire harness connector.
3. Firmly grasp the bulb socket (1) on the back of the lamp lens/housing (4) and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb (3) straight out of the socket.
Installation
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Align the base of the bulb (3) with the socket (1).
