Patriot 4WD L4-2.4L VIN W (2007)
1. Inspect clutch release bearing and lever for excessive wear and replace as necessary. The release bearing is integral to the Concentric Slave
Cylinder (CSC).
2. Clean the surfaces of the flywheel (1) and pressure plate to make certain that all oil, grease, and rust have been removed.
3. Verify the crankshaft mounting flange is free of debris, oil, grease, etc. Position the flywheel (1) onto the engine crankshaft.
4. Install flywheel to crankshaft. Install eight (8) flywheel-to-crankshaft bolts and tighten to 45 Nm (33 ft. lbs.) plus an additional 1/4 turn (90
degrees).
5. Apply a very light coating of grease to the splines in the clutch disc hub.
6. Position the clutch disc (2) to the flywheel (1). Make sure the side marked "FLYWHEEL SIDE" faces the flywheel (1).
7. Install the clutch pressure plate (1) to the flywheel and clutch disc. Finger tighten the six pressure plate-to-flywheel bolts.