Patriot 4WD L4-2.4L VIN W (2007)
Seals and Gaskets: Service and Repair
Input Flange Seal - Installation
INSTALLATION
1. Coat the edge face of the seal with the liquid gasket sealer.
2. Install wave washer.
3. Install the pinion seal using Installer 9931.
4. Install the ECC onto the RDA.
5. Install the mounting bolts (1) that hold the ECC to the RDA and Tighten to 78 Nm (58 ft. lbs.).
6. Plug in the electrical connector (3).
7. Install the propeller shaft.
8. Fill RDA as needed.
9. Lower vehicle and road test.
