jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Fuel Pump - Noise/Whine|Page 2871 > < Fuel Pressure Test Port|Locations
Page 1
background image

Technical Service Bulletin # 145190

Date: 900730

Fuel Pump - Noise/Whine

 Models

1987-90 XJ Body

Subject

Fuel Pump Noise - Vehicles With 4.0L Engine

Index

FUEL

Date

July 30, 1990

No.     

14-51-90

(C14-02-0)
P-2236
BODY CODE LEGEND

XJ - CHEROKEE/WAGONEER

SYMPTOM/CONDITION

Vehicle may exhibit a high frequency noise or whine from the fuel pump. This noise is most noticeable in the passenger compartment at engine idle.

DIAGNOSIS

If the vehicle is a 1987 model, verify that I.S. Note 32E procedure has been performed.  Which has been appended to this tsb.  If the I.S. Note procedure
has been done and the high frequency noise is still present with the engine at idle, proceed with the following repair procedure.

If the vehicle is a 1988-90 model, proceed with the following repair procedure.

PARTS REQUIRED

1

Pulse Damper Kit

PN 83506516

Kit Contents:
1

Pulse Damper

2

Hose Clamps

1

Rubber Hose

1

Instruction Sheet

1

Sending Unit O-ring Seal

PN 53000575

REPAIR PROCEDURE

This procedure involves the addition of a pulse damper to the electric fuel pump to help eliminate fuel pump noise.

1.

Relieve fuel system pressure per the Fuel Pressure Release Procedure in the Service Manual.

2.

Remove the fuel pump/gauge sending unit from the fuel tank. Discard the sending unit O-ring.

NOTE:

Verify that the rubber stopper located on the end of the fuel return tube remained attached when the fuel sending unit was removed from the
tank. If the rubber stopper is not with the sending unit, locate it now and reattach it to the fuel return tube.

3.

Remove the hose and clamps between the fuel pump outlet and the fuel outlet tube.

Fuel Pump - Noise/Whine|Page 2871 > < Fuel Pressure Test Port|Locations